SR20VE Into P10 Hose Question

[2_Liter_Turbo]

I'm working on my SR20VE swap for my LHD P10. I want to replace all of the hoses that are connected to the heater pipes so I don't need to worry about them later on. Anyone know where I can get some P/N's for those hoses? I'm pretty sure the big angled short hose and the one that connects the two metal pipes together (near the thermostat housing) are the same as the P11/B15 roller rocker engines, but the rest I'm not too sure of.

[TheStigP11GT]

They are the same hoses mate. They will fit

[2_Liter_Turbo]

Which ones, all the hoses on the heater pipes?

[TheStigP11GT]

Yeah. The ve and de engine has pipes in the same position

[2_Liter_Turbo]

I think it may be the case there, but after doing some poking around my girlfriends B15 RR motor (which has an EGR valve), they are slightly different (here in the states). The temp sensor housing is completely different, so the hose that goes from the bypass pipes to there is non existent on her motor, but instead has an o-ring directly on the bypass pipe. The big short hose, the one connecting the two pipes, and the front crankcase to VC hose is the same though, so now I just need to figure out the part numbers for the other ones somehow, . I appreciate the comments though, it got me investigating more :pidu: ha ha

[TheStigP11GT]

You got pictures of the differences?

[2_Liter_Turbo]

I don't , but I can see if I can get something to post. I think it's because it's a US car, so it has all the emissions stuff on it, that makes it different.

[TheStigP11GT]

You might get away with uk primera part numbers. Will try and look at fast tonight for you. Pm me your vin number if you can so I can compare